2022 300-625 exam torrent 300-625 Study Guide
Easily pass 300-625 Exam with our Dumps & PDF Test Engine
NEW QUESTION 34
Refer to the exhibit. What is the result of merging the fabric?
- A. The merge is invalid.
- B. The merged fabric IVR VSAN topology is set to activate.
- C. The merged fabric contains only service group Group1.
- D. The merged fabric has NAT enabled.
Answer: C
NEW QUESTION 35
A storage network engineer is implementing disk an ay data replication between two SAN environments in two different data centers not connected via Fibre Channel Which SAN switch feature must be implemented?
- A. VSAN scoping
- B. FCIP
- C. zoning merge over LAN
- D. IVR
Answer: B
NEW QUESTION 36
Which result occurs if a device alias is renamed and then the original device alias name is used in an add command in the same session?
- A. The device alias is renamed and the add command is moved to the rejected list.
- B. The rename command is moved to the rejected list and the add command executes successfully.
- C. Both commands are moved to the rejected list.
- D. Both commands execute successfully.
Answer: D
Explanation:
Section: Implementation
NEW QUESTION 37
A storage network engineer is implementing SAN telemetry for a SAN infrastructure using Cisco DCNM for SAN. Which command is used to check the session status for telemetry operation?
- A. show telemetry control stats
- B. show telemetry transport
- C. show telemetry pipeline stats
- D. show analytics system-load
Answer: C
NEW QUESTION 38
Drag and Drop Question
Drag and drop the items from the left onto the correct descriptions on the right. Not all items are used.
Answer:
Explanation:
NEW QUESTION 39
Refer to the exhibit.
Device alias information must be merged for two fabrics. Which setting must match on both fabrics before the merge can be performed successfully?
- A. qos
- B. device-alias mode
- C. session
- D. smart-zoning
Answer: B
Explanation:
Section: Management and Monitoring
NEW QUESTION 40
A storage network engineer must install and configure a new MDS switch in a data center network. Which two statements about available choices during the MDS switch initial setup are correct? (Choose two.)
- A. The engineer does not have the choice to enable or disable full zoneset distribution.
- B. The engineer can configure the default switch port trunk mode.
- C. The secure password standard is required.
- D. The engineer can configure the default zone policy.
- E. The engineer can choose what will be the administrator account.
Answer: D,E
Explanation:
Section: Implementation
NEW QUESTION 41
A storage network engineer must configure a 48-port Cisco MDS switch to reject any login requests to VSAN 10 from unauthorized Fibre Channel devices and switches. All the devices that were already logged in to the switch from this VSAN must be allowed without any manual configuration. Which configuration must be applied?
- A. switch(config)# port-security activate vsan 10
- B. switch(config)# feature port-security
switch(config)# port-security database vsan 10
switch(config-port-security)# any-wwn interface fc1/1 - fc1/48 - C. switch(config)# feature port-security
switch(config)# port-security activate vsan 10 no auto-learn - D. switch(config)# feature port-security
switch(config)# port-security activate vsan 10
Answer: A
NEW QUESTION 42
Refer to the exhibit.
Refer to the exhibit. A network engineer must configure the SAN telemetry streaming feature to stream statistics from a Cisco MDS 9000 Series Switch to two external receivers with the IP addresses 192.168.1.4 and 192.168.1.5. Which two configurations accomplish this configuration? (Choose two)
- A. Add IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group 100.
- B. Add dst-grp 200 under subscription 100.
- C. Add dst-grp 100 under subscription 200.
- D. Add IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group 300.
- E. Add dst grp 300 under subscription 200.
Answer: B,C
NEW QUESTION 43
Drag and Drop Question
Drag and drop the DCNM configuration tasks from the left onto the correct tools on the right.
Answer:
Explanation:
NEW QUESTION 44
Which configuration is available only in Cisco DCNM-SAN Advanced mode?
- A. template-based provisioning
- B. VMpath configuration
- C. IVR
- D. zoning
Answer: C
Explanation:
Section: Deployment
NEW QUESTION 45
After a subordinate switch requests a domain ID form a principal switch, the requested domain ID becomes the runtime domain ID, and all interfaces on the affected VSAN are isolated.
What is a solution to the issue?
- A. Enable the FICON feature on the affected VSAN.
- B. Configure a static domain on the subordinate switch and reboot the switch.
- C. Configure IVR NAT on the affected VSAN.
- D. Add the received ID to the allowed list.
Answer: D
NEW QUESTION 46
A network engineer must run a core Cisco Nexus 9500 Series Switch as a POAP server for all top-of-rack Cisco Nexus switches. Which two network functions must run to provide the POAP service? (Choose two.)
- A. PXE
- B. DHCP
- C. BOOTP
- D. TFTP
- E. DNS
Answer: B,D
NEW QUESTION 47
Which action must be performed to deactivate a VSAN without losing its configuration?
- A. Suspend it.
- B. Rename it.
- C. Delete it.
- D. Isolate it.
Answer: A
Explanation:
Section: Implementation
NEW QUESTION 48
A storage administrator wants to enable NPV on a Fibre Channel edge switch. Which configuration is supported in this mode?
- A. E Port connectivity to the core switch
- B. Cisco Fabric Services distribution over Fibre Channel
- C. local switching of east-west traffic
- D. Dynamic Port VSAN Membership
Answer: C
NEW QUESTION 49
......
Cisco 300-625 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
300-625 PDF Pass Leader, 300-625 Latest Real Test: https://evedumps.testkingpass.com/300-625-testking-dumps.html